Jump to content


Series 6 white face cluster install into Series 8 - HELP! 

1 reply to this topic

#1 75INNS

  • Joined:08-September 09
  • Location:Australia QLD
  • Car:Series 8 FD3S RX7

Posted 08 September 2009 - 09:58 PM

Hey everyone,

I recently purchased a white-faced 10,000rpm/300kmph instrument cluster.
Have tried installing it, all the plugs are the same and it fits perfectly. When I turn the key to accessories, all lights and guages light up. Turn key again to start car and nothing! Dead silence... You'd think there was no engine!

I take it out, bit freaked.. and start putting my old one back in. Deep breathe...turn key..car starts up first go as per normal!! WTH IS GOING ON?

Can't find anyyyyy information on the internet if there is anything special that needs to be done to make it work.

Help anyone? :D

Edited by 75INNS, 08 September 2009 - 09:59 PM.


#2 QIK RX7

  • Joined:03-August 10
  • Location:Australia QLD
  • Car:rx7 series8

Posted 03 August 2010 - 06:47 PM

hey man just pull the dash inhalf and replace the gauges individually u will only be able to change the gauges applicable to your car ie.speedo,tacho,fuel.the boost gauge and temp gauges are a 1 piece item





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users




dfp


Common Links

  • About Us
  • Privacy Policy
  • User Agreement
  • Help & Support Forums
  • Advertise
  •  

    By your continued use of this site, you agree to follow all Rules & Guidelines and abide by the User Agreement outlined in our Terms & Conditions.

    Hardtuned Network is hosted by Sanity Technology

    Design, Site Management & Hotness provided by Loz.

    Big thanks to all our members and volunteers for making this network what it is today!