Jump to content

madams531

Newbie
  • Content count

    13
  • Joined

  • Last visited

Community Reputation

0 Neutral

About madams531

  • Rank
    Newbie
  • Birthday 04/30/1989

General Info

  • Location
    Australia VIC
  • Gender
    Male
  • Car Type
    Nissan Silvia
  • Car Model
    s13
  • Occupation
    Autoelectrician, Diesel Mechanic
  1. Toyota Corolla KE70 $700

    Sold
  2. Toyota Corolla KE70 $700

    Yeah cash is ok my number is 0437777488 if u are keen
  3. Toyota Corolla KE70 $700

    KE 70 Corolla. Runs and drives, brakes work good. 4K engine, manual gearbox, new spark plugs. Comes with 4 spare wheels. Bit of rust in bonnet and boot lid. Also below fuel filler. Good project car, it's fully stock has not been modified at all. Pick up from Horsham Vic... $700ono
  4. 1.5jz cressida, parted out.cry me a river.

    Swaps for ride on mower??
  5. 1.5jz cressida, parted out.cry me a river.

    Intake looks awesome man
  6. 1.5jz cressida, parted out.cry me a river.

    With ur luck man as soon as u ring another tuner his shop will burn down or sumthin before u get there
  7. 1.5jz cressida, parted out.cry me a river.

    Paint em a brighter colour like orange...High visability... Safety first man
  8. 1.5jz cressida, parted out.cry me a river.

    Drop the starter around man ill hav a look whats wrong with it. Could be easier to fix it than try match another one up
  9. 1.5jz cressida, parted out.cry me a river.

    Fully custom hot air intake. sik
  10. 1.5jz cressida, parted out.cry me a river.

    Na pull the head off and crank it over by hand and see what order your pistons are ready to fire at and make sure its the same as whats programmed into your ecu
  11. 1.5jz cressida, parted out.cry me a river.

    The tacho wire is an output signal will go to the tacho in your dash. so that wont make it not run. The microtech has a maf sensor built into it thats what that air fitting is on the computer isnt it. You could turn your motor over by hand and figure out what the firing order is then make sure its the same as microtech has programmed into your unit. Has to be firing order coz it was sparkin and injectin fuel and all wired up how the book said. Was just outta whack with what the motor was doin
  12. 1.5jz cressida, parted out.cry me a river.

    Found out that the microtech doesnt know the motor is cranking over so its not sending any pulse to the injectors or coils. Checked all sensor signals and crank angle sensor is the only one not sending anything to the microtech, the wires are all ok so we need a new crank angle sensor and that should get it goin...
×