Jump to content
Sign in to follow this  
Adamjdm15

r35 afm with Powerfc!

Recommended Posts

Hey guys not sure of this is the correct part of the forum to post this in but here go's.

 

Has anyone got the flow vs voltage data that i need to put into my powerfc datalogit to run an r35 afm in a 80mm pipe????

 

I know theres a couple of guys on here that r using r35 afms with powerfc. Any help would be great guys!!

Cheers!!

Share this post


Link to post
Share on other sites

Hey man hit up toshi tune on facebook he recommends uaing r35 afms might have your answer

Share this post


Link to post
Share on other sites

just convert nistunes one to power fc - it's pretty straight forward.

Share this post


Link to post
Share on other sites

just convert nistunes one to power fc - it's pretty straight forward.

 

i found that the data was a fair bit out.

 

as apexi use some stupid inhouse forumla to work out its airflow data. nistune use a standardised unit with a K value.

i found i had to re-tune the afm after the install anyways, so the interpolated nistune data is probably close enough to get you a base starting point.

Share this post


Link to post
Share on other sites

^ yes, its close enough -- then you can remap the airflow - only takes bout 1hr.

also the values on nistune have additional numbers which need to adjusted to suit the power fc.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×